Magnum MMG100D Manual del operador descargar pdf (Pagina 15)

• “ALARM CANCEL” Button: When an alarm is activated, either visually or audibly, press this button to silence

or cancel the alarm.

• “FAULT RESET” Button: Press this button to clear the fault from the LCD window after the fault has been

corrected. Press “FAULT RESET” and “ENTER” to clear the John Deere ECU Alarm List Codes.

3. The Liquid Crystal Display (LCD)

• This window will toggle between the Generator Display Screen and the Engine Display Screen upon start-

up of the unit. By viewing these screens, the operator will be able to monitor both the engine and generator

status while the unit is running.

4. The “DIAGNOSTICS” Keypad

• “S” Scroll-Up Button: Press this button to scroll-up within the LCD window.

• “T” Scroll-Down Button: Press this button to scroll-down within the LCD window.

• “PAGE SELECT” Button: Pressing this button will select the next display screen.

• “ENTER” Button: Pressing this button will place you inside the particular display to review the generators

pre programmed setpoints or parameters.

5. The “STATUS” Light Emitting Diodes (LED’s)

• These six LED’s will illuminate to display the current operational status of the generator;

○ Alarm/Fault: Indicates active or inactive alarms, but not reset shut down alarms.

○ Warning: Indicates an active or inactive alarm, or a warning alarm that has not been reset

○ Ready/Manual: Indicates the controller is ready to start and in the manual mode.

○ Ready/Auto: Indicates the unit is in the “AUTO” mode ready for the remote start signal.

○ Running: Indicates the unit is running.

○ Supplying Load: Indicates a load is being applied to the generator.

GENERATOR MONITORING

Generator information is shown on the Liquid Crystal Display (LCD) window in a toggling manner with the Engine

information after the first 60 seconds of operation, then every five seconds thereafter. The generator display screen

will show frequency, line to neutral voltage, line to line voltage and amperage.

Note: When loading the generator, it is important to observe the amperage to determine the load balance on each

line of the generator. Minor load unbalances, usually five percent or less, will not cause any particular problems.

Every effort should be made to distribute the load equally between all lines.

• Hertz: Displays output frequency.

• Generator Output Voltage: Line to Neutral display, single phase (1Ø).

• Generator Output Voltage: Line to Line display, 3 phase (3Ø).

• Amps: Displays the AC output amperage produced by the generator.

ENGINE MONITORING

Engine information is shown on the Liquid Crystal Display (LCD) window in a toggling manner with the Generator

information after the first 60 seconds of operation and then every five seconds thereafter. The engine display screen

will show oil pressure, engine coolant temperature, fuel level and battery voltage.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Sin comentarios

Magnum MMG100D Manual del operador Pagina 15