Magnum MMG100D Manual del operador descargar pdf (Pagina 29)

MDC CONTROLLER INFORMATION DISPLAYS, FUNCTIONS, AND RESET

The Magnum Digital Controller (MDC) constantly monitors vital generator and engine functions for a number of

operation, alarm and fault conditions. When a fault condition occurs, the engine will shut down automatically and the

Liquid Crystal Display (LCD) window will show the fault that has caused the shutdown. To resume operation, the

fault condition must be resolved. To reset the controller and resume operation, press the “FAULT RESET” button.

The operation of the Magnum Digital Controller (MDC) is divided into the following sections:

MAGNUM DIGITAL CONTROLLER (MDC) - GENERATOR OPERATIONAL STATUS

The Magnum Digital Controller (MDC) displays the operational status of the generator using the following codes:

MAGNUM DIGITAL CONTROLLER (MDC) - ALARM MANAGEMENT

The Magnum Digital Controller (MDC) is capable of displaying the following alarms:

No. Engine State Description

1 AfterCool Engine aftercooling, Cooling Pump output is closed.

2 Cooling The unit is cooling before stop.

3 Cranking Engine is cranking.

4 EmergMan Emergency Manual gen-set operation.

5 Init Autotest during controller power on.

6 Not Ready The unit is not ready to start.

7 Pause Pause between start attempts.

8 Prestart Prestart sequence in process, Prestart output is closed.

9 Ready The unit is ready to run.

10 Running The unit is running at nominal speed.

11 Shutdown Shutdown alarm is activated.

12 Starting Starting speed is reached and the idle timer is running.

13 Stop Stop.

No. Electrical State Description

1 StabilTO Stabilization Timeout

No. Type Description

1 Sensor fail (FLS)

Sensor fail is detected when measured value is 6% out of the

selected characteristic. Sensor fail is indicated by ##### symbol

instead of measured value. Note: Oil Temp for John Deere engines

will always display #####.

2 Warning (WRN) When warning comes up, see list of possible alarms.

3 Shutdown (SD)

When the shutdown alarm comes up the digital controller opens

outputs GCB CLOSE/OPEN, FUEL, SOLENOID, STARTER and

PRESTART to stop the engine immediately.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

Sin comentarios

Magnum MMG100D Manual del operador Pagina 29