Magnum MMG75D Manual del operador descargar pdf (Pagina 17)

CONTROL POWER SWITCH

Use this switch to start up and shut down the Power Zone™ controller. This switch should not be turned off when

the unit is running.

ENGINE START

Pressing the Engine Start “I” button while the controller is in “Manual Mode” will start the unit, provided there are no

shutdown errors, and the engine satisfies the start status. If the controller is in “Auto Mode”, the engine start button

has no effect.

ENGINE STOP/RESET

Pressing the Engine Stop/Reset “O” button will shut down the unit and put the controller into Stop Mode, whether in

“Manual Mode” or “Auto Mode”.

CAUTION

In case of an emergency, always press the Emergency Stop switch located on the side of

the unit to stop the engine immediately. The Engine Stop/Reset “O” button may delay the

engine shutdown if stop faults exist.

To prevent damage to the generator and connected equipment, remove all loads from the

generator by opening all circuit breakers (turn to “OFF/O”) before pressing the Engine Stop/

Reset “O” button.

OPERATOR SCREENS

The Operator screens display the most relevant and critical information an operator will need to properly configure

and utilize a unit. From these four screens the operator can access engine, generator and power transmission

information necessary to operate the unit under normal conditions.

HOME SCREEN

The Home screen is the default screen of the controller and will display after the controller is powered up and the

unit management software is loaded. It displays a live readout of the kW meter, percent of load used (gauge), selected

phase, volts and amps being produced by the generator, and the fuel level with time until empty. The controller will

automatically return to this screen from any other screen after a period of inactivity.

ENGINE SCREEN

The Engine screen displays the oil pressure, coolant temperature and battery voltage on three main gauges. Below

the gauges is an hour gauge displaying the total run time on the engine. This screen also displays maintenance

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Sin comentarios

Magnum MMG75D Manual del operador Pagina 17