Magnum MMG75D Manual del operador descargar pdf (Pagina 34)

The voltage selector switch is equipped with a locking mechanism. Once the proper voltage has been selected, push

the red latch on the inside of the switch handle up and insert a padlock through the handle. By locking the handle in

place, you will prevent unauthorized personnel from changing the switch settings.

Note: UNITS WITHOUT A RECEPTACLE BUCK TRANSFORMER: When the voltage selector switch is in position

for 480/277V 3Ø, voltage at the two GFCI duplex receptacles is 139 volts and the voltage at the three twist-lock

receptacles is 240/139 volts. When the voltage selector switch is in position for 208/120V 3Ø, voltage at the three

twist-lock receptacles and the two GFCI receptacles is 208/120 volts.

Receptacles should not be used in the 480/277 voltage setting as the voltage will be higher

and equipment damage could result.

4-POSITION VOLTAGE SELECTOR SWITCH OPTION

The optional four position voltage selector switch is located on a panel attached to the generator behind the door

located next to the fuel tank filler. The voltage selector is a four position switch that mechanically changes the

connections between the generator output leads and the connection lugs on the main control panel. Voltage ranges

are selected by rotating the handle on the switch to the desired voltage.

NEVER CHANGE THE VOLTAGE SELECTOR SWITCH WHILE THE ENGINE IS RUN-

NING. This will cause severe arcing and damage to the switch and generator windings.

The voltage selector switch is equipped with a locking mechanism. Once the proper voltage has been selected, push

the red latch on the inside of the switch handle up and insert a padlock through the handle. By locking the handle in

place, you will prevent unauthorized personnel from changing the switch settings.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

Sin comentarios

Magnum MMG75D Manual del operador Pagina 34